■ Re-enabling the PKSB (Parking Support Brake) system
Additionally, if any of the following conditions are met, the system will be re-enabled
automatically and the driving assist infomation indicator will turn off:
● The P shift position is selected
● The object is no longer detected in the traveling direction of the vehicle
● The traveling direction of the vehicle changes
*1
Turning the PKSB (Parking Support Brake) system ON/OFF
The PKSB (Parking Support Brake) system can be changed between ON (ena-
bled) and OFF (disabled) on the center display.
1
Select .
2 Select [Driving assist].
3 Select [Parking support brake] to change ON (enable)/OFF (disabled).
When the PKSB (Parking Support Brake) is disabled, the driving assist infomation
indicator illuminates.
When turned OFF (disabled), the PKSB (Parking Support Brake) will be disabled
and will not be enabled until the setting is changed to ON again in center display.
(The function will not be reenabled by operating the power switch.)
PKSB (Parking Support Brake) function displays and buzzers
When the hybrid system output restriction control or brake control operates,
a buzzer sounds and a message is displayed on the multi-information display,
head-up display
*
and center display to alert the driver.
Depending on the situation, output restriction control operates to either limit
acceleration or restrict output as much as possible.
■ Hybrid system output restriction control is operating (acceleration restric-
tion)
● Acceleration greater than a certain amount is restricted by the system.
● Multi-information display:"Object Detected Ahead Speed Reduced"
● Head-up display
*
:"Object Detected Acceleration Reduced"
● Center display: No warning displayed
*1 :
Except when the Pedestrians Rear of the Vehicle operated.
* :
If equipped
6-2. Using the safe driving support functions
466
To Next Page
Loading...
