4 Select [Tyre pressure].
5 Select [Set indicated air pressure] and then select the desired front and rear
tire pressures.
6 Select [OK].
The tire pressure warning light will slowly blink 3
times.
After setting the tire inflation pressure, a message
indicating that setting has been completed will be
displayed on the multi-information display.
INFORMATION
■ If the tire inflation pressure cannot be set easily
● If the tire pressure warning light does not blink 3 times when starting the tire
inflation pressure setting procedure, the procedure may not have started. Perform
the procedure again from the beginning.
● If tire inflation pressure setting procedure cannot be completed after performing
the above procedure, contact any authorized Lexus retailer or Lexus authorized
repairer, or any reliable repairer.
Setting using the current tire inflation pressure
WARNING
Make sure to adjust the tire inflation pressure of each tire to the appropriate level before
performing tire pressure setting. Otherwise, the tire pressure warning light may not
illuminate even if the tire inflation pressure drops or may illuminate even though the tire
inflation pressure is normal.
INFORMATION
■ Warning performance of the tire pressure warning system
● When performing the tire pressure setting using the current tire inflation pressure,
the warning timing of the tire pressure warning system will vary according to the
conditions under which tire pressure setting was performed. Therefore, a warning may
be output even if the tire inflation pressure drops slightly or if the tire inflation pressure
increases above that when the tire inflation pressure was set.
● Make sure to perform the tire pressure setting procedure after adjusting the tire
inflation pressure. Also, make sure the tires are cold before performing the tire
pressure setting procedure or adjusting the tire inflation pressure.
8-5. Tire maintenance
629
8
Maintenance and care
To Next Page
Loading...
