1 Adjust the tire inflation pressure of each tire to the appropriate level.
Make sure to adjust the tire inflation pressure with the tires cold.
2 Start the hybrid system.
The tire inflation pressure cannot be set while the vehicle is moving.
3
Select on the center display.
4 Select [Vehicle customise].
5 Select [Tyre pressure].
6 Select [Set current air pressure].
7 Select [Continue].
The tire pressure warning light will slowly blink 3
times and a message indicating that tire inflation
pressure is being set will be displayed on the
multi-information display.
After setting the tire inflation pressure, a message
indicating that setting has been completed will be
displayed on the multi-information display.
INFORMATION
■ Tire inflation pressure setting procedure
● If the power switch is turned off while setting the tire inflation pressure, the next
time the power switch is turned to ON, the setting procedure will resume and it
will not be necessary to restart the procedure.
● If the tire inflation pressure setting procedure is started unnecessarily, adjust the
tire inflation pressure to the specified level with the tires cold and then perform
setting by selecting a specified tire inflation pressure, or perform the tire inflation
pressure setting procedure with the current tire inflation pressure.
■ If the tire inflation pressure cannot be set easily
● Normally, the tire inflation pressure setting procedure can be completed in 2 or 3
minutes.
● If the tire pressure warning light does not blink 3 times when starting the tire
inflation pressure setting procedure, the procedure may not have started. Perform
the procedure again from the beginning.
● If tire inflation pressure setting procedure cannot be completed after performing
the above procedure, contact any authorized Lexus retailer or Lexus authorized
repairer, or any reliable repairer.
8-5. Tire maintenance
630
To Next Page
Loading...
