Registering ID codes
The tire pressure warning valve and transmitter is equipped with a unique ID code.
When new tire pressure warning valves and transmitters are installed, new ID
codes must be registered in the tire pressure warning computer.
INFORMATION
● ID codes can be registered by yourself, but depending on the driving conditions and
driving environment, registration may take some time to complete.
● When using a wheel set which all of the ID codes have already been registered, the
wheel set can be changed in a short amount of time.
Before performing ID code registration, make sure that no wheels with tire pres-
sure warning valve and transmitters installed are near the vehicle.
1 Park the vehicle in a safe place, turn the power switch off and wait 15 minutes
or more.
2 Start the hybrid system.
The ID code registration procedure cannot be performed while the vehicle is moving.
3
Select
on the center display.
4 Select [Vehicle customise].
5 Select [Tyre pressure].
6 Check if the desired wheel set ([Set 1] or [Set
2]) is displayed.
ID codes will be registered to the displayed wheel
set.
To change the wheel set to be registered, select
the displayed set, and then select the wheel set
you wish to register.
If ID codes have already been registered for that
wheel set, the tire pressure warning light will slowly blink 3 times, and a message
indicating that change is occurring will be displayed on the multi-information display.
7 Select [New tyre registration].
8-5. Tire maintenance
631
8
Maintenance and care
To Next Page
