8 Select [Continue].
The tire pressure warning light will slowly blink 3
times and a message indicating that ID code reg-
istration is being performed will be displayed on
the multi-information display. Wheel set changing
will be canceled and registration will begin.
When registration is being performed, the tire
pressure warning light will blink for approximately
1 minute then illuminate and "---" will be displayed for the inflation pressure of each tire
on the multi-information display.
INFORMATION
If the tire pressure warning light does not blink 3 times when starting ID code
registration procedure, the procedure may not have started. Perform the procedure
again from the beginning.
9 Drive straight (with occasional left and right turns) at approximately 40 km/h
(25 mph) or more for approximately 10 to 30 minutes.
When registration is complete, the tire pressure warning light will turn off and a
message indicating that registration has been completed will be displayed on the
multi-information display.
Registration may take longer than normal to complete if the vehicle speed cannot be
maintained at approximately 40 km/h (25 mph) or more. If registration cannot be
completed after driving for 1 hour or more, perform the registration procedure again
from the beginning.
INFORMATION
■ When registering ID codes
● Normally, wheel position registration can be completed within approximately 30
minutes.
● ID code registration is performed while driving at a vehicle speed of approximate-
ly 40 km/h (25 mph) or more.
■ If ID codes are not registered easily
● In the following situations, ID code registration may take longer than usual to be
completed or may not be possible.
• When the vehicle has not been parked for approximately 15 minutes or more
before being driven
•
Vehicle is not driven at approximately 40 km/h (25 mph) or more
•
Vehicle is driven on unpaved roads
8-5. Tire maintenance
632
To Next Page
Loading...
