Preventing the circuit breaker from tripping during charging
When your circuit breaker trips during charging, the upper limit of the charging
current can be changed in [Vehicle customise] on the center display.
*7*8
1 Select on the center display.
2 Select [Vehicle customise].
3 Select [Charging].
4 Select [Charging current].
5 Select [16A]
*9
or [8A] on the charging current screen, and then press [OK].
During charging, the maximum charging current will be restricted to the set current or
lower.
*10
If the breaker still trips while charging, even after changing the upper limit of the
charging current, check if the connected power source meets the specified charging
conditions.
*7 :
The maximum charging current cannot be changed when the power switch is in ACC.
*8 :
If the power supply of the AC charging stand being used has been adjusted or
depending on the AC charging cable being used, the supplied current may be lower
than the set maximum charging current.
*9 :
Vehicles with 7 kW onboard traction battery charger only
*10 :
Restricting the charging current will lengthen the charging time.
1-3. Charging with the plug-in hybrid system
75
1
Before driving
To Next Page
Loading...
