EXTERNAL EQUIPMENT SETUP
To avoid damaging any equipment, never plug in any power cord until you have finished connecting all equipment.
Image shown may differ from your TV.
HD RECEIVER SETUP
This TV can receive Digital RF/Cable signals without an external digital set-top box. However, if you do receive Digital signals
from a digital set-top box or other digital external device, refer to the diagram as shown below.
Connecting with a Component Cable
Connect the video outputs (Y, PB, PR) of the digital set top box to the
COMPONENT IN VIDEO jacks on the TV.
Connect the audio outputs of the digital set-top box to the COMPONENT
IN AUDIO jacks on the TV.
Turn on the digital set-top box. (Refer to the owner’s manual for the digital
set-top box.)
Select Component input source using the INPUT button on the remote
control.
Signal Component HDMI
480i/576i O X
480p/576p O O
720p/1080i O O
1080p
O
(50/60Hz only)
O
(24Hz/30Hz/50Hz/60Hz)
■
■
■
GB-10
EXTERNAL EQUIPMENT SETUP
To Next Page
Loading...
