GB-12
EXTERNAL EQUIPMENT SETUP
EXTERNAL EQUIPMENT SETUP
DVD SETUP
Connecting with a Component Cable
Connect the video outputs (Y, PB, PR) of the DVD to the COMPONENT IN
VIDEO jacks on the TV.
Connect the audio outputs of the DVD to the COMPONENT IN AUDIO
jacks on the TV.
Turn on the DVD player, insert a DVD.
Select Component input source using the INPUT button on the remote
control.
Refer to the DVD player’s manual for operating instructions.
Component Input Ports
To achieve better picture quality, connect a DVD player to the component input ports as shown below.
Component ports on the TV
Y PB PR
Video output ports on DVD
player
Y
Y
Y
Y
PB
B-Y
Cb
Pb
PR
R-Y
Cr
Pr
Connecting with an HDMI Cable
Connect the HDMI output of the DVD to the HDMI/DVI IN 1 or HDMI IN 2 jack on
the TV.
Select HDMI1 or HDMI2 input source using the INPUT button on the remote
control.
Refer to the DVD player’s manual for operating instructions.
NOTE
The TV can receive video and audio signals simultaneously when using a HDMI
cable.
If the DVD does not support Auto HDMI, you must set the output resolution
appropriately.
Check that your HDMI cable is version 1.3 or higher. If the HDMI cables don’t
support HDMI version 1.3, flickering or no screen display can result. Please use
the latest cables that support at least HDMI version 1.3.
►
►
►
To Next Page
Loading...
