LG 22LU7000 - VCR Setup

GB-14
EXTERNAL EQUIPMENT SETUP
EXTERNAL EQUIPMENT SETUP
VCR SETUP
To avoid picture noise (interference), allow adequate distance between the VCR and TV.
Connecting with a RF Cable

Connect the ANT OUT socket of the VCR to the ANTENNA IN socket on the TV.

Connect the terrestrial antenna cable to the ANT IN socket of the VCR.

Press the PLAY button on the VCR and match the appropriate channel between
the TV and VCR for viewing.
Connecting with a RCA Cable

Connect the AUDIO/VIDEO jacks between TV and VCR. Match the jack
colours (Video = yellow, Audio Left = white, and Audio Right = red)

Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR
owner’s manual.)

Select AV3 input source using the INPUT button on the remote control.
NOTE
If you have a mono VCR, connect the audio cable from the VCR to the
AUDIO L/MONO jack of the TV.
►
L
R
S-VIDEO
VIDEO
OUTPUT
SWITCH
ANT IN
ANT OUT
OUTPUT
SWITCH
ANT IN
R
S-VIDEO VIDEO
ANT OUT
L
(RGB)
ANTENNA
IN
(RGB)
(R) AUDIO (L)
AUDIO/
VIDEO
1
1
2
ANTENNA
IN
1
L
R
S-VIDEO
VIDEO
OUTPUT
SWITCH
ANT IN
ANT OUT
OUTPUT
SWITCH
ANT IN
R
S-VIDEO VIDEO
ANT OUT
L
(RGB)
ANTENNA
IN
(RGB)
(R) AUDIO (L)
AUDIO/
VIDEO
1
1
2
(RGB)
ANTENNA
IN
1
Wall jack
Antenna