Function Code Zone State fixing mode
Press button for 4 seconds
to enter the installer setting
mode until timer segment
display “01:01”.
1
Press button to exit or
system will automatically exit
after 25 seconds without any
input.
5
Repeat pressing button to select
Function code 11.
Ex) Setting Zone State as 'Fixed'.
2
Select Zone State rate fixing mode by
pressing button.
(01: Variable, 02: Fixed)
3
Press button to save or release.
4
Installation instruction
Installer Setting-Zone State Setting
This function is only available on some products.
It is possible to setup Variable or Fixed option for Zone State of indoor. The initial setting is 'Variable'
To Next Page
Loading...
Need help?
General
