Owner’s & Installation Manual 9
ENGLISH
Installation instruction
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it can cause problems to the product, user injury or
property damage. This must be set by an certificated installer, and any installation or change that is
carried out by a non-certificated person should be responsible for the results. In this case, free service
cannot be provided.
Function Code Value
1
Press button for 4 secsonds to enter
the installer setting mode. (When you
enter the setting mode initially, Function
code is displayed on the bottom of the
LCD screen.)
1
Repeat pressing button, the menu
will change with the corresponding
function code.
Test Run → Address Setting → E.S.P.
Value → Thermistor → Ceiling Height →
Static Pressure → Group Setting →
Override Setting → Dry Contact →
Release 3Min. Delay → Zone State →
Convert Temp. → Plasma → Electric
heater → Humidifier → Elevation Grill →
Ventilation Kit
2
To Next Page
Loading...
Need help?
General
