Owner's instruction
40 Wide Wired Remote Controller
Programming : Setting Simple Reservation
Press button to enter the
Programming mode.
(the segment flashing)
Ex) Setting Simple Reservation
time as '3'.
1
Press button to adjust
reservation time.
2
Press button to finish setting.
3
Adjusting the reservation time after finish
reservation setting will release the
previous one.
4
In case of there is not any reservation setup on system, it is possible to make a SIMPLE reservation
on indoor unit.
❊ If the indoor is ON, we can make the reservation for turning OFF. In reserve, if the indoor is OFF,
we can set the timer for turning ON. The reservation time is from 1 to 7 hours.
To Next Page
Loading...
Need help?
General
