1. Connect the USB data cable into
the wall adapter, as shown below.
2. Gently uncover the phone's
accessory/ charger port. Then
plug the USB data cable (as
shown in the next image) into the
accessory/ charger port and the
other end into an electrical
outlet.
The charge time varies
depending upon the battery level.
Charging with USB
You can use your computer to
charge your phone. To be able to
charge with the USB cable, you may
need to have the necessary USB
Driver installed on your PC first.
Connect one end of the USB cable
to the accesory/charger port on
your phone and the other end to a
bus-powered USB port on your PC.
NOTE
Low-powered USB ports are not
supported, such as the USB port
on your keyboard or bus-powered
USB hub.
NOTE
If the phone is about to reset, a
warning message will appear on
the home screen.
How to Install a microSD
TM
Card
1. Locate the microSD slot on the
right side of the phone, then
uncover the slot.
19
Wall Adapter
NOTICE
Please make sure that the
'B' side is facing up before
inserting a charger or data
cable into the charger port
of your phone.
microSD
TM
slot
To Next Page
Loading...
Need help?
General
