COMPONENT ACCESS
3-5
CERAMIC GLASS COOKTOP REMOVAL
Step. 1
Unplug the cord or disconnect power
Step. 2
Remove lamp, controller and back cover
(See the page 3-2)
Step. 3
Remove wiring from the
cooktop assembly.
Step. 4
Open oven door and
remove the 3screws located
at the front of the cook-top,
then close the door.
Step. 5
Lift up the cooktop
assembly and turn the
cooktop assembly over
(protect the cooktop
surface).
REMOVING THE SURFACE ELEMENTS
AND THE CERAMIC GLASS COOKTOP
WARNING
• DISCONNECT power supply cord
from the outlet before servicing.
• Replace all panels and parts before
operating.
• RECONNECT all grounding devices.
- Failure to do so can result in severe personal
injury, death or electrical shock.
Step. 6
To remove the surface
elements
a) Remove the wires from
the element and limiter
terminals.
b) Remove the element
brackets for the element you are servicing and
the element can be detached.
REASSEMBLY NOTE: When you reinstall the
element, make sure that the wires are inserted into
the correct tap and that the brackets are secured
firmly. When wiring, refer to the technical card in
order to prevent wires and connectors from
mismating.
To Next Page
Loading...
Need help?
General
