25
ENGLISH
Installation
InstallationPrecautions
• Place the projector in a well-
ventilated environment.
- To prevent internal
overheating, install the
projector in a well-ventilated
place. Do not place anything
near the projector that may
block its air vents. If the air
vents are blocked, the internal
temperature of the projector
will increase.
- Do not place the projector
on a carpet or rug. If the
projector's inlet vent is on
the bottom, be careful not to
block the vent and always use
the projector on a solid, level
surface.
- Be sure to prevent foreign
objects such as paper debris
from entering the projector.
- Leave an adequate open area
(30 cm or more) around the
projector.
• Do not place the projector in a
hot, cool, or humid environment.
• Do not place the projector in a
place where it will easily attract
dust.
- This may result in re.
• Never open any cover on the
projector. There is a high risk of
electric shock.
• The projector is manufactured
using high-precision technology.
You may, however, see tiny
black dots and/or bright colored
dots (red, blue or green) that
continuously appear on the
projector screen. This is a normal
result of the manufacturing
process and does not indicate a
malfunction.
• The remote control may not work
in an environment where a lamp
equipped with electronic ballasts
or a three-wavelength fluorescent
lamp is installed. Replace the
lamp with an international
standard lamp for the remote
control to work normally.
To Next Page