LG PZRCUSB0 User Manual

E.S.P(Outflow)
14 Ventilation Wired Remote Controller
E.S.P(OUTFLOW)
1
If you press the Timer button and the Ventilaton mode
button simultaneously for about 3 seconds, you can
enter the ESP value setting mode.
2
Using the Delay low/high button, set the ESP value for
each air speed (Low, Mid, High). Use the Fan speed
button to decide the Fan Speed. (The ESP value can
be set between 1 to 255.)
3
After completing the ESP setting, press the Timer
button and Ventilaton mode button simultaneously for
about 3 seconds to exit the ESP value setting mode.
* Because the ESP value is already appropriately factory set, it is recommended that you do not change the
ESP value.
What is an E.S.P function?
This is the function that decides the strength of the air for each air speeds and because this function is to make
the installation easier, please do not use this function when using the remote controller.
Delay Time
Set no. Timer
Timer
Program set Sun Mon Tue Wed Thu Fri Sat
On Off
Fan SpeedCentral Run Heat XCH
PLASMA
Filter Time
e-SAVER
fresh
Heater Preheat
Defrost
Humidify
SUB FUNCTION
Z O N E
1 2 3 4
Auto
Hi
SHi
Linked Run
Auto Normal
EXTERNAL VENTILATOR OPERATION
Auto
Dual Remote
TIME RESET
Lo
Timer Cancel
Program Week
Hour Min
Holiday
Set/Clr
fresh
Auto
Plasma

LG PZRCUSB0 Specifications

General

Brand	LG
Model	PZRCUSB0
Category	Remote Control
Language	English