LG PZRCUSB0 User Manual

Normal Fan Speed
Linked Run
Central Run Heat XCH Auto
Auto
EXTERNAL VENTILATOR OPERATION
Dual Remote
Auto
PLASMA
Timer
Program set Sun Mon Tue Wed Thu Fri Sat
On Off
Set no. Timer
Filter Time Delay Time
e-SAVER
fresh
Heater Preheat
Defrost
Humidify
SUB FUNCTION
Lo
Hi
SHi
TIME RESET
Z O N E
1
Timer Cancel
Program Week
Hour Min
Holiday
Set/Clr
fresh
Auto
Plasma
Linked Run
Central Run Heat XCH Auto Normal Fan Speed
Heater Preheat
Defrost
Humidify
PLASMA
Timer
Program set Sun Mon Tue Wed Thu Fri Sat
On Off
Auto
Set no. Timer
EXTERNAL VENTILATOR OPERATION SUB FUNCTION
Filter
Time Delay Time
e-SAVER
Auto
Lo
Hi
SHi
Dual Remote
fresh
Z O N E
1
Address Setup for Airconditoner -Ventilator Connection
Owner’s & Installation Manual 11
1
Set the air conditioner remote control to set the
central control address of each indoor unit.
2
Press the Timer and Hour button simultaneously for
about 3 seconds. Now remote controller enters into
the mode to input a start address of the connected
air conditioner while displaying operation area 1.
3
Using the Delay low/high button, set the start
address of connected air conditioner
(ex : in case of the air conditioner's address 01~08,
set the start address 01 from ventilation remote
controller)
4
When address setting is finished, press the Timer
and Hour button simultaneously about 3 seconds.
This completes the setting of start address.
Address Setup for Airconditoner -Ventilator Connection
< Setting of start address >

LG PZRCUSB0 Specifications

General

Brand	LG
Model	PZRCUSB0
Category	Remote Control
Language	English