14
Connection to an
Connection to an
Amplifier
Amplifier
Connecting to an amplifier equipped with two channel analog stereo or Dolby Pro Logic II/Pro Logic
Connect the Left and Right AUDIO OUTPUT jacks on the Recorder to the audio left and right in jacks on your
amplifier, receiver, or stereo system using the audio cables (A) supplied.
Connecting to an amplifier equipped with two channel digital stereo (PCM) or to an Audio/Video receiver
equipped with a multi-channel decoder (Dolby Digital™, MPEG 2, or DTS)
1. Connect one of the Recorder’s DIGITAL AUDIO OUTPUT jacks (OPTICAL, COAXIAL) to the corresponding in
jack on your amplifier. Use an optional digital (Optical (O), Coaxial (X)) audio cable.
2. You will need to activate the Recorder ’s digital output. (See [Audio Settings] on page 53).
Due to the DTS Licensing agreement, the digital output will be in DTS digital out when DTS audio stream is
selected.
If the audio format of the digital output does not match the capabilities of your receiver, the receiver will produce a strong, distorted
sound or no sound at all.
Six Channel Digital Surround Sound via digital connection can only be obtained if your receiver is equipped with a Digital Multi-
channel decoder.
To see the audio format of the current DVD in the on-screen display, press AUDIO.
This Recorder does not perform internal (2 channel) decoding of a DTS sound track. To enjoy DTS multi channel surround,
you must connect this Recorder to a DTS compatible receiver via one of this Recorder’s digital audio outputs.
While viewing a digital channel, the 2 channel stereo audio is only output through the audio output jacks.
A digital multi-channel connection provides the best sound quality. For this you need a multi-channel Audio/Video receiver that
supports one or more of the audio formats supported by your Recorder (MPEG 2, Dolby Digital and DTS). Check the receiver
manual and the logos on the front of the receiver.
Notes
Notes
Caution
Caution
To Next Page
Loading...
Need help?
General
