67
REFERENCE
HDMI
The connected HDMI b Try disconnecting then reconnecting the HDMI cable.
device does not display b Try switching the power of the HDMI device off then back on.
any picture. b The video input of the connected device is set correctly for this unit.
b The HDMI cable you are using is fully HDMI-compliant.
Using a non-standard cable may result in no picture being output.
b Not all HDCP-compatible DVI devices will work with this unit.
The connected HDMI b Some HDMI-compatible devices do not output sounds
device does not (check the manual that came with the connected device).
output sounds. b If your TV is not capable of handling 96 kHz sampling frequency, set the [Sampling Freq.] option
to [48 kHz] on the setup menu. When this choice is made, this unit will automatically convert any
96 kHz signals to 48 kHz so your system can decode them.
b If your TV is not equipped with Dolby Digital and MPEG decoder, set the [Dolby Digital] and
[MPEG] options to [PCM] on the setup menu.
b If your TV is not equipped with DTS decoder, set the [DTS] options to [OFF] on the setup menu.
To enjoy DTS multi channel surround, you must connect this unit to a DTS compatible receiver via
one of this unit’s digital audio outputs.
Resetting the unit
If you observe any b The unit is plugged in, but the power will not turn on or off.
of the following b The front panel display is not working.
symptoms. b The unit is not operating normally.
You can reset the b Press and hold the POWER (
11
) button for at least five seconds.
unit as follows. This will force the unit to power off then turn the unit back on.
b Unplug the power cord, wait at least five seconds, and then plug it in again.
To Next Page
Loading...
