LG Single "A" - Installer Setting-How to Enter Installer Setting Mode

- 32 -
Copyright ©2008 LG Electronics. Inc. All right reserved.
Only for training and service purposes
LGE Internal Use Only
Part 2 Functions & Controls
Installer Setting -How to enter installer setting mode
Installer setting mode is to set the detail function of the remote controller.
If the installer setting mode is not set correctly, it can cause problems to the product, user injury or property dam-
age. This must be set by an certificated installer, and any installation or change that is carried out by a non-certifi-
cated person should be responsible for the results. In this case, free service cannot be provided.
Function Code Value
1
Press button for 4 secsonds to enter
the installer setting mode. (When you
enter the setting mode initially, Function
code is displayed on the bottom of the
LCD screen.)
1
Repeat pressing button, the menu
will change with the corresponding
function code.
Test Run → Address Setting → E.S.P.
Value → Thermistor → Ceiling Height →
Static Pressure → Group Setting →
Override Setting → Dry Contact →
Release 3Min. Delay → Zone State →
Convert Temp. → Plasma → Electric
heater → Humidifier → Elevation Grill →
Ventilation Kit
2
j Some contents may not be displayed depending on the product function.