TRAINING MANUAL WM0742HGA
WM0742HGA Page 12 TRAINING MANUAL
ACCESSORIES
The washer comes with the two input hoses. The blue stripe is for cold water and the red
stripe is for hot water. The hoses are not mechanically identical. It is critical to the
performance of the washer to have the hot and cold hoses connected correctly. The hot
hose is a thicker material suitable for higher temperatures and pressure.
The wrench is used to remove (and replace) the shipping bolts and to adjust the leveling
feet. Be sure to leave it and encourage the customer to retain the wrench, the four
shipping bolts, and the manual in a safe place in the event the washer requires service or
the customer moves.
The shipping bolts MUST BE REMOVED before operating the washer. (See page 13.)
The wrench, shipping bolt hole covers,
drain hose tie down strap, and a sample
packet of detergent are included in a
packet shipped inside the washer.
See page 29 concerning detergent usage.
To Next Page
Loading...
