LG WM0742H Series - Dispenser; Noise Filter (Electronic)

TRAINING MANUAL WM0742HGA
WM0742HGA Page 34 TRAINING MANUAL
DISASSEMBLY and REPAIR, continued
DISPENSER
Remove the 5 hose clamps. If you squeeze
them and slide them a couple of inches
down the hose, they will not be lost while
the repair is made.
Pull the 5 hoses off the connectors on the
dispenser. Reassembly will be very
convenient later if you mark the hoses now.
Remove the clamp on the large hose
attached to the dispenser. (When you
replace it, set it with the screw on top and
the wing nut on the bottom for easier
reach in the future.)
Pull the large hose off the dispenser and
remove the dispenser from the machine.
Unplug all the solenoids. (As with the
hoses, reconnection will be more
convenient if you mark the connectors
and valves now.)
Remove the two screws at the back of the
machine and lift out the solenoid array.
NOISE FILTER
To service the noise filter, remove the
control panel cover.
Unplug the two connectors of the noise
filter and slide it out of the clips on the
frame.