TRAINING MANUAL WM0742HGA
WM0742HGA Page 16 TRAINING MANUAL
PEDESTAL, continued
Depending upon the model, your pedestal
may have straight or curved brackets. The
curved ones are to be used on the rear
positions when mounting a dryer to a
pedestal, but can also be used in any other
position on the pedestal.
Holding the exposed adhesive away from
the appliance, insert the screws and get
them started. Then press the brackets to
the appliance and tighten all the screws.
Rub the bracket from side to side to ensure
a complete bond.
Use the wrench to turn each leg of the
appliance approximately ¼ turn to put a
little pressure between the appliance and
the pedestal. This will eliminate any
rattles and vibration.
It is usually easier to set the pedestal and
washer into place and connect the water
and drain hoses before placing the dryer
on top of them.
To Next Page
Loading...
