INSTALLATIONINSTRUCTIONS13
Unpacking and removing shipping bolt"s
When removing the washer from the carton base, be sure to
remove the foam drum support in the middle of the carton
base
If you must lay the washer down to remove the base
packaging materials, always lay it carefully on its side
De NOT lay the washer on its front or back.
Foam Tub Carton Base
Support
Remove the bottom two shipping bolts with the wrench
(included) to fully loosen all four shipping bolts by turning
them counterclockwise and then pulling them out.
Sh,pp,ng
bolt _
Locate the four hole caps included in the accessory pack
and install them in the shipping bolt holes
@ NOTE
• Save the bolt assemblies for future use. To prevent
damage to internal components, DO NOT transport the
washer without reinstalling the shipping bolts
Failure to remove shipping bolts and retainers may
cause severe vibration and noise, which can lead to
permanent damage to the washer. The cord is secured
to the back of the washer with a shipping bolt to help
prevent operation with shipping bolts in place.
\ J
To Next Page
Loading...
