LG WM3050CW - Connecting the Drain Line; Drain Hose Installation and Securing

INSTALLATION INSTRUCTIONS 15
Connecfing fhe drain line
Secure the drain hose in place to prevent moving and leaking
:-@ NOTE ........................................................................................................................................................_,
• The drain hose should be properly secured Failure to
properly secure the drain hose can result in flooding and
malfunction
• Total height of the house end should not exceed 96
inches (2448 cm) from the bottom of the washer
• The drain must be installedinaccordance with any
applicablelocalcodes and regulations.
• Make sure thatthe water linesare net stretched,
pinched, crushed, or kinked.
.... J
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from
the end of the drain hose. If the drain hose is extended
more than 4 inches (10 cm) beyond the end of the elbow
bracket, mold or microorganisms could spread to the
inside of the washer
NO more than
4 inches (10 cm)
racket
2 Insert the end of the drain hose into the standpipe
Elbow Bracket
3 Use a tie strap to secure the drain hose in place.
Clip the end of the hose into the elbow bracket.
- Connect the elbow bracket within 4 inches (10 cm) from
the end of the drain hose If the drain hose is extended
more than 4inches (10 cm) beyond the end of the elbow
bracket, mold, or microorganisms could spread to the
inside of the washer.
NO more than
4 inches (10 cm)
racket
2 Hang the end of the drain hose over the side of the laundry
tub.
_ Elbow Bracket
3 Use a tie strap to secure the drain hose in place