LG WM3677HW - Page 47

COMBO
WM3677 COMBO Page 47 of 68 TRAINING MANUAL
TUB REMOVAL AND REPAIR, continued.
11. Remove the clamp where
the dryer duct connects to
the gasket. Separate the
gasket and duct for when
the tub comes out. This will
allow the dryer assembly to
remain in place when the
tub comes out.
12. Remove the three dampers
that support the tub.
BE CAUTIOUS! Separated
dampers must be replaced.
Press in the tab on the
small end and use the pliers
to push the pin out. It is
easiest to remove the
bottom pin first. After
removing the drum, the pin
on the other end is easy to
reach if it must be removed
at all.
13. Use special tool
383EER4003A to remove
the pins. Press the security
tab in to push the pin
through.
Attach the larger, metal end
to the drum and the smaller,
plastic piston end to the
frame of the COMBO.
(Insert the pins from the
front on the two side
dampers, and from the right
on the rear damper.)