Configuration Basics
Configuration Command Summary
16-18 Using the LI-6400
16
ÒReset to Factory DefaultsÓ
This program is designed to put the LI-6400 into a ÒknownÓ state quickly. It
simply implements the master list without any user list. It is functionally
equivalent to ÒReset to User ConfigÓ, and selecting “Factory Default” (provid-
ed “Factory Default” is an empty file).
The user is prompted for one thing:
Re-install config files? (Y/N).
Pressing Y will reinstall the configuration files (on the current config disk,
typically /User). Pressing N will skip that, and pressing escape will abort.
ÒReset to User Configuration
This program allows the user to select a configuration (provided there is more
than just “Factory Defaults” in the “Configs/UserPrefs” directory. After implement-
ing the master list, the user is prompted to select a configuration (Figure 16-1
on page 16-3), and it is then implemented.
Configuration Command Summary
The following commands can be used in a configuration file. For the most up
to date list valid for whatever version of OPEN you are running, press the
Help function key in the Configuration Menu. There may be changes de-
scribed there that occurred after this writing.
AREA=
Sets the leaf area parameter. Note that this can be set in New Measurements
mode as well. Leaf area is a system variable (ID number -33).
Strip Chart Definitions
Configs/StripDefs
Photo & Cond
DeltaCO2, DeltaH2O, Flow
A-Q, g-Q, totalCV
A-Q, RH-Flow, totalCV
A-Ci, RH-Flow, totalCV
A-Ci, totalCV, CO2S
Config Files
Configs/UserPrefs
Factory Default
Table 16-3. (Continued) Files installed by Config File Reinstall.
Category Destination directory Files to be overwritten
To Next Page
