Water Tank Operation
After cleaning, the dust box can be replaced with water tank assembly if mopping is required.
1. Paste the water seepage cloth
Push through the two fixing corners of the water seepage cloth along the lower end of the duster cloth, paste the
water seepage cloth securely, and mount the water seepage cloth bracket to the base of the robot in alignment.
2. Feed water
Open the rubber plug of the water filling nozzle, slowly fill water into the water tank, and secure the rubber plug
after the water tank is filled.
3. Install the tank assembly
Open the middle cover of the robot, withdraw the dust box, and simply place the filled water tank into the empty
slot.
4. Mop the floor
Activate any cleaning mode on demand, and then the robot will perform the cleaning operation.
Tips:
1. During the robot's mopping process, if the operation is suspended due to refill water or clean the duster cloth, the robot will replan the planned route
upon restart, to re-clean the cleaned area. In order to achieve better cleaning performance, it is recommended to use the robot in a single room when
mopping.
2. If a second room needs to be cleaned, it will be recommended to manually move the robot to the second room and refill the water tank or clean the
duster cloth as appropriate.
3. If multiple rooms need to be cleaned, refer to the above Paragraph 2 before cleaning please.
4. Please do not use the water tank assembly on any blanket. Upon cleaning operation using the duster cloth feature, please fold the edge of the
blanket to avoid that foreign matters on the duster cloth may pollute the blanket.
5. When cleaning, please pay attention to water filling or clearance timely, and open the tank plug during water filling.
6. When charging, please remove the water tank assembly.
14
To Next Page
Loading...
