12 5
12 6
Connection points are shown as below:
620
620
Complet ely-d ischarg ed
battery
Negat ive pol e
conne ctor (“ －”)
Recha rgeab le battery
Jumper ca ble
c. Connect the clip of the negative
pole (black) of the jumper cable
to the equivalent connector (－)
of the rechargeable battery.
d. Connect the clip of the other end of
negative pole (black) of the jumper
cable to a me tal fixed point used for
grounding in the vehicle wi th a
comp letely- discharged battery.
Connection points of jump- starting
engine
Do not contact the jumper cable to
any movable components during
starting the engine.
Tips
To avoid any severe personal injury
during connection, do not approach
the battery or carelessly connect
the jumper cable or clip to any other
objects except the correct battery
connectors or earth points.
4. Start the engine in the normal way.
Then lightly step on the accelerator
pedal and make the engine rotate at
a speed of 2,000 rpm.
5. Carefully dismantle the cable reverse
to the installation procedure; firstly
dismantle the negative pole cable and
then the positive pole cable.
6. Carefully take off the cloth on the battery
which may be stuck to by electrolyte.
In case that the battery discharges due to
unclear reasons (e.g. the light still
illuminates), you should contact the
service station for check.
Lifan
If the Engine Misfires during
Driving
If the Vehicle is Over-heated
3. Check if there is an evident leakage
in the radiator, hose and underside of
the vehicle. However, it is normal in
case of drips from A/C in use.
If the engine misfires during driving…
1. Slowly decelerate the vehicle and
carefully drive the vehicle off the road
to a safe place.
2. Open the emergency light.
3. Turn the ignition key to “ACC” or
“LOCK”, and restart the engine.
If the engine still can not start, refer to
“If the Vehicle Can Not Start”.
Note
In case that the engine does not run,
the power assisting device of the
brake and steering gear will not
fully work. Therefore, it is much
difficult than usual to carry out the
steering and braking.
The engine may be over-heated in case
of an over-heated indication on the
coolant thermometer, or loss of power,
or a knocking sound or bang noise.
Please take the following treatment
procedures…
1. Drive the vehicle safely off the road,
park it and open the emergency light.
Set the shift knob at neutral position
and pull up the parking brake. In case of
using A/C, close it.
2. Stop the engine in case of coolant or
steam ejecting from the radiator or the
reservoir. Open the engine hood after
the steam fades away. Keep engine
working and close the ignition switch
in case of no coolant or steam
ejection.
Warning
To avoid personal injury, keep the
engine hood closed until there is no
steam any more. The flowing of steam
or coolant indicates a rather high
pressure.
Warning
Your hands and clothes should keep
a certain distance with the fan and
engine belt in operation when the
engine runs.
d
c
Instru cti on Manual of Lifa n Sedan
LIFAN
Instru cti on Manual of Lifa n Sedan
Instru cti on Manual of Lifa n Sedan
LIFAN
Chongqing Lifan Passenger Vehicle Co. , Ltd.
Chongqing Lifan Passenger Vehicle Co. , Ltd.
To Next Page
Loading...
