15 3
15 4
Notes for Maintenance DIY
620
620
To carry out maintenance DIY, it is
necessary to do as per the correct
procedures in this section.
This section is just for some maintenance
work which is easy to carry out for users.
As mentioned in Chapter 6, the first and
regular maintenance must be carried out
by professional technicians using special
tools in Lifan service station.
During maintenance work, be especially
careful to avoid incidental injuries. The
following prevention measures should
be abode by especially.
Warning
●When engine runs, hands, clothes and
tools should be far away from the running
fan and engine belt. (Better to take off
things like ring, watch and tie.)
●If the engine is too heated, then don't
take off the radiator cap or loose the
drainage plug, for avoiding burns.
●Never leave behind such flammable
articles as paper, cloth in the engine
compartment.
●Before working around the grille plate
of cooling fan or radiator, it is necessary
to make sure that the ignition switch
is turned off. When the ignition switch
is turned on, if the temperature of
●When t he car has exactly finished a
driving, the temperature of engine
comp artment—engine, radiator, exhau st
pipe, power-assisted steering flui d storage
tank , spark plug etc. is very high. So
be careful not to touch. The temperature
of oil , coolant and spark plug is also
very h igh.
●Open flames are strictly proh ibited around
fuel tank or battery, for avoiding a fire.
●When disposing the battery, be especially
careful, for the battery contains co rrosive
electrolyte.
Warning
●When the car is only jacked by body
jack, people don't come under the car,
do support the car with support frame or
other strong strut.
●Whether working above or below the car,
goggles are to be worn, for avoiding falling
or dropping articles and spa ttering fluid.
Note
●Remember that, both battery and
ignition coil bear high current or voltage.
Be careful to prevent accidents resulting
in short circuit.
●If the coolant is overflowing, it is
necessary to clean it with water, for
avoiding damaging components or paint
coat.
●Prevent any miscellany from dropping
into the spark plug hole.
●Strictly prohibit to pry the outer electrode
beside the central electrode of spark plug.
●Only use the spark plug of designated
model.
●No overfill the power-assisted steering
fluid, or the power- assisted steering
will be damaged.
●If the brake fluid is overflowing, it is
necessary to clean it with water, for
avoiding damaging components or paint
coat.
●Strictly prohibit to drive when the air
cleaner is taken off, or it will result in
excessive wear of engine.
Note
●Be careful not to scratch the windshield
by the wiper.
●When closing the engine hood, check
whether there is anything like tools, cloth
etc left behind the engine compartment.
engine coolant rises or the A/C is
turned on, the electrical cooling fan
of engine will run automatically.
Instru cti on Manual of Lifa n Sedan
LIFAN
Instru cti on Manual of Lifa n Sedan
Instru cti on Manual of Lifa n Sedan
LIFAN
Chongqing Lifan Passenger Vehicle Co. , Ltd.
Chongqing Lifan Passenger Vehicle Co. , Ltd.
To Next Page
Loading...
