EasyManua.ls Logo

Lifan LF620 - Chongqing Lifan Passenger Vehicle Co., Ltd

Lifan LF620
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
620
Replace wheel
Don't use old wheels for replacement,
because these wheels may be treated
or serve a long mileage, and may go
wrong without any warning. Meanwhile,
the twisted wheels having undergone
alignment always have structural
damages, so don't use them either.
Don't use the inner tube specially
designed for tires without inner tube
inside a flat tire.
Notes for aluminum alloy wheel
620
When to replace the wheel
If there are damages like twist, crazing
or severe corrosion in the wheel, it is
necessary to make a replacement.
If don' t replace the damaged wheel,
then the tire may separate from the
wheel or it will make the car lose
control.
Selection of wheel
In case of replacing the wheel, be sure to use
a wheel of the same specification and model
with the replaced one.
The service station can carry out correct
wheel replacement.
Lifan
Wheels of different sizes or types will bring
about bad effect to the control, service life of
wheel and bearing, cooling of brake, calibration
of the speedome ter/odome ter, brake
performa nce, headlight aiming, height of
bump er, car height above the ground and
the space between the tire or tire chain and
the vehicle body and chassis.
Warning
Since wheels of different sizes will
cause typical operation danger
which in turn makes the car lose
control, therefore, do not use any
wheel with a size not recommended
by the manufacturer. Otherwise,
accident will occur.
The car installed with aluminum wheels,
after the initial 1600km, it is necessary to
check whether the nut is screwed.
●In case of the exchange, repair or
replacement of tires, check whether the
nut is screwed after driving for 1 600km.
When using the tire chain, be careful not
to damage the aluminum alloy wheel.
Only use the wheel nut and wrench
specially designed for aluminum wheel.
●When using the tire chain to adjust the
wheel balance, only use balancer or
tools equal to it and plastic hammer or
rubber hammer.
Like all vehicles, it is necessary to check
whether there is damage of aluminum
wheels timely. If damages are found, it is
necessary to replace it for a new one
immediately.
Maintenance DIY
1 65
16 6
Check the battery
Check and replace fuse
Section 7-3
16 3
16 4
Electrical Components
Instru cti on Manual of Lifa n Sedan
LIFAN
Instru cti on Manual of Lifa n Sedan
Instru cti on Manual of Lifa n Sedan
LIFAN
Chongqing Lifan Passenger Vehicle Co. , Ltd.
Chongqing Lifan Passenger Vehicle Co. , Ltd.

Table of Contents

Related product manuals