33
Assembling Your Elliptical
Step 6: Console Attachment
A. Remove pre-installed
M5x10L bolts and M5
washers from the back
of Console (6) with 4mm
Allen Wrench.
B. Connect two 6-pin wire harnesses and
one 7-pin wire harness from mast to console.
Connect two 2-pin pulse grip wires. The E3i model has two additional
ramp and level 3 pin wires to connect marked “R” and “L”.
C. Connect optional Bluetooth Module (sold separately) using
instructions supplied.
A
To Next Page
Loading...
