LifeSpan Super - General Cleaning and Care

EVERY 6 MONTHS
It may be necessary to lubricate your treadmill running deck at least once every six months
to maintain optimal performance of your treadmill (refer to section 4.4 for information).
Please contact Lifespan Fitness with questions about applying lubricant to your treadmill.
• Turn off the treadmill with the on/off switch, then unplug the power cord at the wall outlet.
• Loosen both side of rear roller bolts. (For best results, place two removable marks on both
sides of the frame and note roller position).Once the belt is loosen, take the bottle of
lubricant and apply it to the entire top surface of the running deck. Tighten both rear roller
bolts (matching up the marks for proper position) to original position. After you have applied
lubricant, plug in the power cord, key, start the treadmill and walk on the belt for two minutes
to spread the lubricant.
• Lubricate the air shocks with Teflon based spray.
SERVICING: IF YOU FAIL TO COMPLY WITH LIFESPAN’S MAINTENANCE AND
SERVICING STEPS ABOVE, YOU MAY VOID YOUR WARRANTY. IF YOU REQUIRE A
SKILLED LIFESPAN REPRESENTATIVE TO UNDERTAKE ONE OF THE STEPS ABOVE,
PLEASE EMAIL US AT lifespanfitness@hotmail.com.
2 General Cleaning
 Use a soft, damp cloth to wipe the edge of the belt and the area between the belt edge
and frame. A mild soap and water solution along with a nylon scrub brush will clean the
top of the textured belt. This task should be done once a month. Allow to dry before
using.
 On a monthly basis, vacuum underneath your treadmill to prevent dust build up. Once
a year, you should remove the black motor shield and vacuum out dirt that may
accumulate.
3 General Care
 Check parts for wear before use.
 Pay particular attention to the fixing knobs and make sure they are tight.
 Always replace the mat if worn and any other defective parts.
 If in doubt do not use the treadmill and contact our helpline.
TAKE CARE TO PROTECT CARPETS AND FLOOR in case of leakages. This product is a machine
that contains moving parts which have been greased / lubricated and could leak.