Display shows a normal
operation, the strap,
however, operates
improperly and suffers from
a cacophony.
The input voltage is
too low.
The input power should
meet the requirement.
The electric running
machine operates normally
with no load but halts
midway.
The strap becomes
loose.
Adjust the strap following
the specification.
The display fails to work
normally or cannot display
at all, and the keys don’t
work.
The electronic meter
is influenced by an
external factor.
Disconnect the power
supply and switch off
switches, and restart the
electric running machine
5min later.
E01. Bad communication (impropriate plunge of trunk’s terminal or wires cracked)
E02. Abrupt force (excessive torsion stress from controller)
E03. Bad signal of induction lines (no speed can be detected. Please adjust the position of signal
wires’ magnetic induction and plug the junction of induction lines firmly)
E04. Incline system failure (press on the test button on controller to retest it, then turn-on
the machine) (Normally we don’t suggest customer to do this themselves, it’s dangerous if they are
not familiar wit
h it.)
E05. Over current protection from controller (low current’s parameter setting of controller. Reset
parameter or change controller)
E06. Controller self-test failure. (Change controller)
WARRANTY REGISTRATION
Please visit the following link to complete the product warranty form online. Please visit
http://warrantyform.lifespanfitness.com.au/
PLEASE NOTE: YOUR WARRANTY IS ONLY VALID IF YOU CAN PROVE YOU ARE
THE ORIGINAL PURCHASER ON THIS ITEM (i.e. a copy of the receipt, invoice,
delivery date or internet confirmation).
To Previous Page
Loading...
