Note: Adjustment is thru the small hold on the end caps.
Tighten the rear roller only enough to prevent slippage at the front roller. Turn both the
right and left bolt clockwise reasonably and inspect for proper tension. When an
adjustment is made to
the belt tension, you must also make a tracking adjustment to
compensate for the change in belt tension.
DO NOT OVERTIGHTEN - Over tightening will cause belt damage and premature bearing
failure.
7. Belt Tracking Adjustment:
This treadmill is designed to keep the belt reasonably centred while in use. It is normal for
some belts to drift near one side while the belt is running with no one on it. After a few
minutes of use, the belt should have a tendency to centre itself. If during use, the belt
continues to move toward one side, adjustments are necessary. The procedures are as
below:
first set speed at lowest position.▲
second check the belt shifts to which side.▲
If the belt shifts to right, tighten the right bolt and loosen the left bolt by using 6mm
Hexagonal Wrench, until the belt is centered itself; If belt shifts to left, tighten the left bolt
and loosen the right bolt by using 6mm Hexagonal Wrench, until the belt is centered. When
adjusting the belt using the 6 mm Hexagonal Wrenches, it is important to adjust the belt in
half turn increments. Over adjusting the belt can cause damage to the mat.
8. Solutions for Failure Elimination
Failure Possible Reason Solution
The power supply is
connected and the electric
running machine has
started, however, there is no
any display.
1 ． The socket and
power supply is
not connected
well.
2 ． The socket of
electric motor is
not connected
well.
3 ． The fuse is
burned.
1．Insert the socket a
To Next Page
Loading...
