Lighthouse REMOTE 3104P, 5104P Operating Manual
3-12 248083336-1 Rev 3
Peripheral
Interface
Connector
The round Peripheral Interface Connector (PIC) (Table 3-4) on the rear
of the REMOTE 3104P or 5104P can be used to connect an external
peripheral device such as an alarm buzzer, alarm light or a remote start/
stop controller. Contact Lighthouse Technical Support for details.
Data The REMOTE 3104P or 5104P stores its data (including analog data
when applicable) in a 3000-record rotating data buffer.
The data can be downloaded real-time to LMS Express RT, RT+ or to a
Lighthouse Monitoring System. The instrument can also run standalone
until you decide to view the data. The data can then be downloaded to
LMS Express or LMS XChange manually.
A real-time system will allow you to monitor the instrument counts on
a minute-by-minute basis or for the length of the sample time. Using
LMS Express Real Time (RT) to download the data allows for
historical trending of the data.
Use the optional REMOTE Display to view the data as it is being
collected.
With any of the data download transfer software, you can save the data
to an Excel xls file, a CSV file or to an HTML file.
Please refer to the data transfer software manuals for more information.
Table 3-4 PIC Connector Pin-Outs
Pin Connection
1 24 VDC
2 GND
3 Alarm+
4 Alarm-
5 Start/Stop
6 Not Connected
7 Not Connected
8 GND
To Next Page
Loading...
