00
248083336-1 Rev 3 A-1
A
MODBUS Register
Map v1.48, Rx104P
COMM
Settings
Lighthouse particle counters using MODBUS require the following
communications settings:
The MODBUS slave address is set on the particle counter.
Supported
MODBUS
Commands
See www.modbus.org for documentation on how to use these
commands.
Table A-1 MODBUS Communications Settings
Baud Rate 19200
Data Bits 8
Stop Bits 1
Parity None
Hardware Protocol RS485, USB and Ethernet
Software Protocol MODBUS ASCII (supports upper/lower case)
MODBUS TCP
Table A-2 MODBUS Registers
Hex Command Description
03 Read Holding Registers
04 Read Input Registers
06 Write Single Holding Register
To Next Page
Loading...
