705iR User Manual
15 | 705iR User Manual
INITIAL SET-UP: OPTIONAL HM-70
3. Grip the barrel in the center section.
Avoid covering the infrared emitters
circling the base. This could interrupt
signal transmission.
1. Turn the 705iR power knob clockwise.
The LED above the CH A POWER
switch will ash RED one time to
indicate the power is on.
4. While speaking in a normal voice,
increase the CH B volume level
until your voice is barely audible.
REMEMBER: This equipment is
designed to supplement and
distribute the user’s voice
so they are able to speak
in a conversational tone.
Having the volume set too
high will result in feedback
and listener fatigue.
2. Turn on the HM-70 by
sliding the switch to the
top position. On the 705iR,
the GREEN IR LED above
the CH B knob will light to
indicate a signal is being
received. The HM-70 is set
to Channel B at the factory.
To Next Page
Loading...
