6
1. Overview 2. Installation
3. Optional
Installation
SYSTEM COMPONENTS AND UNPACKING
The standard configuration of the Topcat
®
will contain:
Topcat
Media Connector
and Power Supply
SECTION 1:
OVERVIEW
NOTE ON REGISTRATION: The Topcat, Microphone(s) and Media Connector
are pre-registered together at the Lightspeed factory as required for proper
operation. If paired components are separated and swapped during the
installation process, they must be re-registered. Please refer to the registration
instructions in the Troubleshooting section of the User Manual.
Lightspeed recommends that the microphone(s), Media Connector and/or
the accessory box be labeled with the room number of the Topcat that the
components are registered with for proper dispersement.
To assist in this process, Lightspeed has labeled each registered component
with a system number. If components become separated, simply match them
up by this number for proper operation.
AUDIO INMICROPHONE AUDIO OUT
POWER
MIN
LINK
MAX MIN MAX MIN MAX
To Next Page
Loading...
