Lightware VINX-120AP-HDMI-ENC-DNT - Built-In Web or LDU2; Important Notices - before Starting the Upgrade; About the Firmware Package (LFP;LFP2 File); Option 1. - Upgrading Via the Built-In Web Page

7. Firmware Upgrade VINX-1x0-HDMI Extenders – User's Manual 78

7.1. Built-in Web or LDU2

the methods:
Function Built-in Web LDU2
Platform

Google Chrome

mac OS
Installation

needed only
Required


-

 
 -

7.2. 
▪ Upgrade all VINX devices

▪ signal processing is not performed. The normal operation mode is
suspended as the device is switched to bootload mode.
▪ Do not interrupt
▪ The settings and parameters (e.g. User EDID memory, video wall settings) will not be lost by upgrading

7.3. 

device.
▪ 

▪ 
             
loading.
7.4. 
WARNING!  Never disconnect the power source from the VINX devices during the upgrade! Interrupting


you do not have the chance to install a software or you have just a few devices.
7.4.1. Firmware Upgrading Steps
Step 1. Get the necessary rmware pack (*.lfp or *.lfp2 le
device).
Step 2. Establish the connection
in the .
Step 3. Navigate to the Advanced Settings tab.
Step 4. Upgrade Firmware section and press the Choose le 
OK.
Firmware Upgrade via the Built-in Web Page
Step 5. Press the Upgrade Firmware
process is started automatically.
Step 6. The progress bar and a short label will show the current state of the process.
Step 7. 
off and on again the device is recommended.
INFO:  



