Linak SMPS-T160

Label for SMPS-T160:
5. Input: 100-240VAC 50/60 Hz 1.6 A
Input voltage for the product and maximum current consumption
6. Duty Cycle.: 10%, Max. 2 min./18 min.
The duty cycle defines the maximum period during operation without interruption. After operation, a pause
must be observed. It is important that the operator follows the instructions of the duty cycle; otherwise, a
possible overload may result in reduced product life/errors
7. W/O: #1234567-0001
The LINAK work order followed by a unique sequential identification number
1. Item no.: SMPST160+6U2110
Sales and ordering code
2. Prod. Date.: YYYY.MM.DD
Production date describes when the product has been
produced. This date is the reference for warranty claims.
4. Output: 29VDC 5.5A IPX6 Class 2 power supply
Describes the maximum load that the product can be
exposed to in compression and tension. This line also
contains a reference to the product’s IP protection
degree
Key to symbols:
The following symbols are used on the SMPS-T160 label:
Symbol Norms Approvals
WEEE Directive 2002/96/EC Wheelie bin
Compliance to all relevant EC directives CE
Australian Regulatory Compliance Mark –
EMC, Electrical safety
RCM
China Pollution control mark (also indicates recyclability) China RoHS legislation
ISO 7000- 0434A: Caution
IEC 60417-5172:
Class II equipment
Operating instructions
Page 22 of 28