IS09 ECN2087
4
Warnings and Precautions
Please read the following carefully before commencing work on this equipment.
A competent installation engineer, in accordance with the installation instructions of this
appliance and all relevant local and national standards including the following must install this
appliance:
• Health and Safety at Works Acts
• IEE regulations
• BS Codes of Practice
• Local and National Building Regulations
• Fire Precautions Act 1971
• EN 60335-1:1994, EN 60335-2-21:1999, EN 60335-2-63:1993, EN 60529:1992 and BS 3456
part 102 section 102.21:1988
It is mandatory that all appliances are installed, commissioned and serviced by a qualified
and competent person as defined by the regulations in force in the country of installation.
During normal use of the appliance certain surface areas will become hot. These areas are
especially in the vicinity of the facet and spigot. Care should be taken to avoid potential injury
from burns and scolding whilst operating the appliance.
Scale formation within hot water appliances is problematic and more so in hard water areas.
Damage to the appliance caused by excessive scale build up may invalidate the warranty – see
notes on de-scaling.
Use only the supplied parts with the appliance. Introducing foreign components not approved by
the manufacturer may cause tainting of the water and may also invalidate the warranty.
Do not place foreign objects in the tank of the appliance.
Parts explosion, circuit and wiring diagrams are the sole property of Lincat and must not be
reproduced without the consent of the manufacturer.
To Next Page
Loading...
