Handling consumables
ENVIRONMENT NOTE
Consumables must be handled properly and
in accordance with the manufacturer's instruc-
tions.
●
Consumables must be stored only in con-
tainers that comply with the applicable regu-
lations and at the locations stipulated
●
Do not allow flammable consumables to
come into contact with hot objects or naked
flames
●
When topping up consumables, use only
clean containers
●
Observe the manufacturer's instructions re-
lating to safety and disposal
●
Avoid spillages
●
Clean up spilled liquids immediately using
suitable binders; dispose of these in accord-
ance with regulations
●
Old and contaminated consumables must
be disposed of in accordance with the appli-
cable regulations
●
Comply with the statutory provisions
●
Before performing lubrication work, filter
changes or any work on the hydraulic sys-
tem, carefully clean the area around the rel-
evant part
●
Dispose of used spare parts in an environ-
mentally responsible manner
WARNING
Pressurised hydraulic fluid penetrating the skin, e.g.
due to leakage, is dangerous. If an injury of this type
occurs, consult a doctor.
Wear protective equipment.
WARNING
The improper handling of coolant and coolant addi-
tives presents a risk to health and the environment.
Observe the manufacturer's instructions.
Safety
2
Handling consumables
17Operating Instructions - 1131 801 1601 EN - 12/2021 - 04
To Next Page
Loading...
