The safety regulations supplied by the bat-
tery and charger manufacturer must be
strictly observed.
Charging procedure
Ensure that charging requirements are
complied with.
Park the truck as specified.
Remove the key switch (1) to turn off the
power, and then take the plug-in lithium-ion
battery out before charging.
CAUTION
The charging voltage range is 100–240 V, 50–60 Hz.
Do not exceed this voltage range.
Disassembling and installing the
battery
Before disassembling and installing the bat-
tery, you must raise the forks to their highest
position and then turn off the truck’s power
supply.
Disassembly/installation steps:
4
Operation
Battery Use and Maintenance
50 Operating Instructions - 1131 801 1601 EN - 12/2021 - 04
To Next Page
Loading...
