© 2017 Linkam Scientific Instruments Ltd.
12
v1.1.0
·
ta p the Max vacuum button (2) to set the stage pressure to the lowes t it ca n atta in.
·
ta p the blue value under Set point (3) to ma nually set a pres sure level
and ta p the sta rt button (4) to confirm.
Expansion board setup
All vacuum ca pable stages will ha ve a vacuum expa nsion board fitted to their T96 controller, which ha s the following setup screen, a ccessed by
ta ping on the setup bar and taping on the blue a rrow:
The only cha nges that ca n be made are to switch the displa yed units between mBa r, mTorr and kPa. This cannot be changed while a profile is active.
Systems shipped with a MV196 motoris ed vacuum valve will als o be fitted with a motor control expans ion boa rd:
No cha nges can be ma de on this screen, it is for informa tion only.
Pressure stages
This section applies to all stages tha t can be pressuris ed to above atmospheric pressure, Including THMS600PS and CCR1000
The only additional information displayed for pres sure stages is the press ure, in Bar or Mpa (1). There are no additional controls .
Expansion board setup
All pressure ca pable stages will ha ve a pres sure expans ion board fitted to their T96 controller which ha s the following setup screen, accessed by
ta pping on the setup bar and tapping on the blue arrow:
To Next Page
Loading...