© 2017 Linkam Scientific Instruments Ltd.
21
v1.1.0
Options and Information
This section describes the setup and option screens in the LinkPad softwa re.
Connected hardware
Informa tion and options screens for the connected ha rdwa re ca n be accessed by ta ping on the settings icon at the top left of the main s creen.
T96 options
·
This screen displays information concerning the model and serial number of the connected temperature controller and the ra ting of the interna l
power supply.
·
The ma ins frequency can be cha nged between 50 and 60Hz, using the radio buttons (1).
·
The number of decimal places dis played on the tempera ture readout can be selected us ing the ra dio buttons (2). Either one, two or three decimal
pla ces can be us ed. For high temperature TSXXXX sta ges this changes from 0 decimal places to 1 decimal place.
·
Ena bling the 'Enable signa l o/ps' checkbox (3) brings up a repres entation of the green and pink rear pa nel 3.5mm connectors on the ma in running
dis play, a nd allows you to configure their signa l profile
·
If the 'Show sta ge power' box is checked, the power currently being s upplied to the heating block will be dis played on the main screen, in amps
and volts.
Stage options
This screen shows the model and seria l number of the connected sta ge and allows the configuration of Sample Calibration.
Linkpad options
To Next Page
Loading...
Need help?
General