The access points within a cluster must have the same management VLAN configured. A cluster
can support 16 LAPAC2600access points as long as they are same model number.
In each cluster, one access point must be manually configured as the master access point. There
can only be one master in a cluster. This master will propagate configuration information, such as
wireless settings, time settings etc. to the other team members within a cluster. Login to the
master access point to change sharable parameter settings instead of slaves.
When firmware is upgraded on the master, all slaves within the same cluster will receive the
upgrade.
Clustered access points share these configurations:
•
User Accounts
•
Time Settings
•
Log Settings
•
Management Access
•
Discovery Settings
•
IGMP/MLD Snooping
•
Wireless Network
Mode
•
SSID Settings
•
Wireless Security
•
Rogue AP Detection
•
Wireless Scheduler
•
Wireless Scheduler
Association
•
Wireless Connection
Control
•
Rate Limit
•
QoS
•
Advanced Wireless
Settings
•
Captive Portal
Settings
•
Ethernet Port
Settings
•
VLAN Settings
•
ACL Settings
These configurations are not shared by clustered access points:
•
IP Settings
•
WDS
•
Output Power
•
Hostname
•
Workgroup Bridge
•
Wireless Channel
•
802.1x Supplicant
84
To Next Page
Loading...
