To Next Page

To Previous Page

Internet Phone Adapter with 2 Ports for Voice-over-IP

Chapter 4: Using the Phone Adapter’s Interactive Voice Response Menu

Overview

Chapter 4: Using the Phone Adapter’s Interactive Voice

Response Menu

Overview

You may need to manually configure the Phone Adapter by entering the settings provided by your Internet phone

service provider. This chapter explains how to use the Interactive Voice Response Menu to configure the Phone

Adapter’s network settings. You will use the phone’s keypad to enter your commands and select choices, and the

Phone Adapter will respond with voice responses.Accessing the Interactive Voice Response Menu

Accessing the Interactive Voice Response Menu

1. Use a telephone connected to the PHONE 1 or PHONE 2 port of the Phone Adapter.

2. Press the * (star) key four times.

3. Wait until you hear “Configuration menu. Please enter option followed by the

# (pound) key or hang up

to exit.”

4. Refer to the table on page 10 for a list of actions, commands, menu choices, and descriptions. After you

select an option, press the # (pound) key. To exit the menu, hang up the telephone.

NOTE: If your Internet phone service provider sent you the Phone Adapter, then it may be

pre-configured for you, and you do not need to change any settings. Refer to the instructions

provided by your service provider for more information.

Linksys PAP2T User Manual

Other manuals for Linksys PAP2T