Linksys RE4100W - Wait for solid light on RE3000 W V2; Connect to RE3000 W V2 Network; Launch RE3000 W V2 Setup; How to Access RE3000 W V2 Settings

2. Wait for a solid light
It could take up to a minute for the light on the front of the range extender to stop
blinking.
3. Connect to the range extender
On a computer, phone or tablet, connect to the Wi-Fi network Linksys Extender Setup.
4. Launch setup
Enter http://extender.linksys.com in a browser and follow the on-screen instructions to
set up your range extender.
TIPS
• You can also connect the range extender by using Wi-Fi Protected Setup™. For more
information, see “Using Wi-Fi Protected Setup” on page 25
.
• After setup use the extender’s settings interface to change any settings. If connected to
your range extender go to extender.linksys.com.
How to Access the Settings Interface
After setup use the extender’s settings interface to change any settings.
On a computer or device that is connected to your range extender, open any browser
(Internet Explorer, Chrome, Firefox, Safari, etc.), and enter extender.linksys.com
in the
address bar.
23