Linksys WAP54G - Figure 5-4: Power on the Access Point Screen; Figure 5-5: Check the Access Points Status Screen

11
Chapter 5: Setting up the Wireless-G Access Point
Using the Setup Wizard
Wireless-G Access Point
5. Connect the power adapter to the Access Point and an electrical outlet. Then click the Next button.
6. Make sure the Access Point’s Power, Act, and Link LEDs are lit on its front panel. If they are not, check your
cable connections. Then click the Next button to continue.
Figure 5-4: Power on the Access Point Screen
Figure 5-5: Check the Access Point’s Status Screen